Proto Advantage Custom Interposers |
|
![](images/pixel_trans.gif) |
In addition to our huge selection of off-the-shelf adapters, we also design and manufacture custom interposers to adapt any IC. We use cutting edge 3D CAD software and our in-house robotic assembly line to ensure tight quality control.
|
![](images/pixel_trans.gif) |
|
![](images/pixel_trans.gif) |
Interposers are often used to replace obsolete ICs. This allows customers to keep their PCB and assembly process the same, while using a custom interposer as a drop-in replacement.
|
![](images/pixel_trans.gif) |
|
A few examples of interposers we've manufactured are shown below.
|
![](images/pixel_trans.gif) |
SOIC to DIP
![](images/InterposerPage/SOIC-DIP_0.JPG) ![](images/InterposerPage/SOIC-DIP_1.JPG)
SSOP to DIP
![](images/InterposerPage/SSOP-DIP_0.JPG) ![](images/InterposerPage/SSOP-DIP_1.JPG)
SOIC to DIP edge mount
![](images/InterposerPage/SOIC-EDGE-DIP_0.JPG) ![](images/InterposerPage/SOIC-EDGE-DIP_1.JPG)
BGA to Flat Pack, with integrated decoupling capacitors
![](images/InterposerPage/BGA-FP_0.JPG) ![](images/InterposerPage/BGA-FP_1.JPG)
BGA to TSSOP, with integrated pull-up resistor
![](images/InterposerPage/BGA-TSOP_0.JPG) ![](images/InterposerPage/BGA-TSOP_1.JPG)
QFN to QFN, with plated shut blind/buried vias
![](images/InterposerPage/QFN-QFN_0.JPG) ![](images/InterposerPage/QFN-QFN_1.JPG)
DIP to SSOP, with custom keep-out routing
![](images/InterposerPage/DIP-SSOP_0.JPG) ![](images/InterposerPage/DIP-SSOP_1.JPG)
|
![](images/pixel_trans.gif) |
|
![](images/pixel_trans.gif) |
Our interposers use cutting edge PCB and pin technology. Here's a list of our current standard capabilities:
- 0.003" (0.075mm) space/trace routing
- 0.004" (0.1mm) laser drilled blind/buried vias
- 0.006" (0.15mm) laser drilled through hole vias
- 1/32" (0.8mm) to 1/4" (6.35mm) PCB thickness
- 2-30 layers, including power and ground planes if needed
- Custom edge routing, cut outs, slots, and castellation notches
- 0.4mm pitch BGA, QFN, LGA, and 0402 parts
- Through hole and surface mount pins, gold plated
|
![](images/pixel_trans.gif) |
|
![](images/pixel_trans.gif) |
Standard lead time for prototype interposers is 1-3 weeks. Standard lead time for production interposers is 4-6 weeks.
|
![](images/pixel_trans.gif) |
|
![](images/pixel_trans.gif) |
Prototype quantities of 2+. Production quantities of 100 to 10,000+. Our pricing is very competitive, with full assembly of top side IC, pins, and auxiliary components available. Contact us today for a quote.
|
![](images/pixel_trans.gif) |